よくある質問

A laminar ring is a specific variation of spiral rings stacked together to form a labyrinth seal, preventing dust and grease leakage in bearing assemblies.

A single multi-turn ring is engineered as one unified component, preventing internal friction, misalignment, and installation errors seen when nesting loose single rings.

Heavy-duty configurations utilize flat wire thicknesses ranging from 1.0 mm up to 4.0 mm or more for large heavy-industrial shafts.

Standard multi-turn spiral rings are highly symmetrical, which provides outstanding balance and smooth performance in rotating machinery.

Spiral rings typically feature a small, uniform gap between the wire ends or a overlapping configuration depending on specific clearance requirements.

The primary function is to replace traditional bulky fastening components (like nuts, threaded collars, cotter pins) by acting as a removable shoulder to secure parts axially.

Yes, parameters like diameter, turn count, wire thickness, and material can be customized easily through coiling machine programming changes.

A constant-section ring is also made of flat wire with a uniform cross-section, but it typically has a single turn with a gap, unlike multi-turn spiral rings.

They are designed to interchange with standard industrial and military configurations, complying with aerospace specifications (AS) and standard global industrial groove dimensions.

A self-locking ring features a tab-and-slot design on the turns that mechanically locks the ring into the groove under high rotational speeds, preventing it from expanding due to centrifugal forces.

Light-duty rings have thinner wire cross-sections for low loads and tight spaces. Heavy-duty rings feature wider and thicker wire profiles designed to withstand extreme thrust forces.

Because they are manufactured using an edgewise coiling process rather than stamping dies, custom sizes can be produced rapidly without expensive tooling charges.

An external spiral ring is designed to contract securely into a groove machined on the outside diameter of a shaft or pin.

An internal spiral ring is designed to expand tightly into a groove cut inside a cylinder, bore, or housing to retain internal components.

It provides uninterrupted contact with the retained component, ensuring completely uniform load distribution and eliminating weak points around the groove circumference.

A 2-turn spiral retaining ring consists of two continuous turns of coiled flat wire layered together, doubling the thickness and significantly increasing thrust capacity compared to a single-turn ring.

Spiral rings have a uniform cross-section and lack the protruding assembly 'ears' or lugs of stamped rings, saving radial space and providing a sleek, smooth profile.

A spiral retaining ring (or Spirolox style ring) is a retaining ring formed by coiling flat wire on edge to create a 360-degree continuous retaining surface with no ears or lugs to interfere with mating parts.

Measure the free height of the spring before installation and re-measure it after compression. A significant, permanent reduction indicates the spring took a set due to over-stressing.

Stainless steel and superalloy springs have an indefinite shelf life. Carbon steel springs have an indefinite structural shelf life if kept dry and properly lubricated against rust.